Chrysler 200 2012 Guide de l'utilisateur télécharger pdf (Page 62)

Programming A Rolling Code

• For programming Garage Door Openers that were manufactured after 1995. These

Garage Door Openers can be identified by the “LEARN” or “TRAIN” button located

where the hanging antenna is attached to the Garage Door Opener. It is NOT the button

that is normally used to open and close the door. The name and color of the button may

vary by manufacturer.

• Place the ignition switch into the ON/RUN position.

• Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink® button

you wish to program while keeping the HomeLink® indicator light in view.

• Simultaneously press and hold both the Homelink button you want to program and the

hand-held transmitter button.

• Continue to hold both buttons and observe the indicator light. The Homelink® indicator

will flash slowly and then rapidly after Homelink® has received the frequency signal from

the hand-held transmitter. Release both buttons after the indicator light changes from

slow to rapid.

• At the garage door opener motor (in the garage), locate the “LEARN” or “TRAINING”

button. This can usually be found where the hanging antenna wire is attached to the

garage door opener motor. Firmly press and release the “LEARN” or “TRAINING”

button.

NOTE: You have 30 seconds in which to initiate the next step after the LEARN button has

been pressed.

• Return to the vehicle and press the programmed HomeLink® button twice (holding the

button for two seconds each time). If the device is plugged in and activates, programming

is complete.

NOTE: If the device does not activate, press the button a third time (for two seconds) to

complete the training.

• To program the remaining two HomeLink® buttons, repeat each step for each remaining

button. DO NOT erase the channels.

Programming A Non-Rolling Code

• For programming Garage Door Openers manufactured before 1995.

• Turn the ignition switch to the ON/RUN position.

• Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink® button

you wish to program while keeping the HomeLink® indicator light in view.

• Simultaneously press and hold both the Homelink button you want to program and the

hand-held transmitter button.

• Continue to hold both buttons and observe the indicator light. The Homelink® indicator

will flash slowly and then rapidly after Homelink® has received the frequency signal from

the hand-held transmitter. Release both buttons after the indicator light changes from

slow to rapid.

• Press and hold the programmed HomeLink® button and observe the indicator light.

ELECTRONICS

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 107 108

Pas de commentaire

Chrysler 200 2012 Guide de l'utilisateur Page 62