Chrysler 200 2012 Guide de l'utilisateur télécharger pdf (Page 19)

ENGINE BREAK-IN RECOMMENDATIONS

• A long break-in period is not required for the engine and drivetrain (transmission and

axle) in your vehicle.

• Drive moderately during the first 300 miles (500 km). After the initial 60 miles (100 km),

speeds up to 50 or 55 mph (80 or 90 km/h) are desirable.

• While cruising, brief full-throttle acceleration within the limits of local traffic laws

contributes to a good break-in. Wide-open throttle acceleration in low gear can be

detrimental and should be avoided.

• The engine oil installed in the engine at the factory is a high-quality energy conserving

type lubricant. Oil changes should be consistent with anticipated climate conditions under

which vehicle operations will occur. For the recommended viscosity and quality grades,

refer to “Maintaining Your Vehicle”. NON-DETERGENT OR STRAIGHT MINERAL

OILS MUST NEVER BE USED.

• A new engine may consume some oil during its first few thousand miles (kilometers) of

operation. This should be considered a normal part of the break-in and not interpreted as

an indication of difficulty.

TURN SIGNAL/LIGHTS LEVER

Headlights/Parking Lights/Automatic Headlights

• Rotate the end of the lever to the first detent for parking lights , the second detent

for headlights

and the third detent for AUTO.

• When set to AUTO, the system automatically turns the headlights on or off based on

ambient light levels.

Instrument Panel Dimmer

• Rotate the center portion of the lever to the extreme bottom position to fully dim the

instrument panel lights and prevent the interior lights from illuminating when a door is

opened.

OPERATING YOUR VEHICLE

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 107 108

Pas de commentaire

Chrysler 200 2012 Guide de l'utilisateur Page 19