Chrysler 200 2012 Guide de l'utilisateur télécharger pdf (Page 14)

• If lowered, raise the convertible top.

NOTE: The convertible top must be in the UP position to access the tether anchor.

• Open the access port cover behind the seat where you are placing the child restraint.

• Push the tether strap and hook through

the access port and down into the trunk.

NOTE: Route the tether strap to provide the

most direct path from the child seat to the

anchor.

• From inside the trunk, open the access

cover on the carpet covering the back of

the seat and attach the tether strap hook

to the anchor.

• Tighten all three straps as you push the

child restraint rearward and downward into

the seat.

Installing The Child Restraint Using The Vehicle Seat Belts

• To install a child restraint, first, pull enough of the seat belt webbing from the retractor to

route it through the belt path of the child restraint and slide the latch plate into the

buckle.

• Next, extract all the seat belt webbing out of the retractor and then allow the belt to

retract into the retractor. Finally, pull on any excess webbing to tighten the lap portion

around the child restraint. Any seat belt system will loosen with time, so check the belt

occasionally, and pull it tight if necessary.

• If lowered, raise the convertible top.

NOTE: The convertible top must be in the UP position to access the tether anchor.

• Open the access port cover behind the seat where you are placing the child restraint. The

access ports to the top tether anchorages are directly behind the seat headrests under a

plastic cover.

• Push the tether strap and hook through the access port and down into the trunk.

NOTE: Route the tether strap to provide the most direct path from the child seat to the

anchor.

GETTING STARTED

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 107 108

Pas de commentaire

Chrysler 200 2012 Guide de l'utilisateur Page 14