Chrysler 200 2012 Guide de l'utilisateur télécharger pdf (Page 74)

7. Lower the vehicle by turning the jack

screw to the left.

8. Finish tightening the nuts. Push down on

the wrench while at the end of the handle

for increased leverage. Tighten the lug

nuts in a star pattern until each nut has

been tightened twice. The correct wheel

nut torque is 100 ft lbs (135 N·m). If you

doubt that you have tightened the nuts

correctly, have them checked with a

torque wrench by your authorized dealer

or at a service station.

9. Remove the wheel blocks and lower the jack until it is free. Reassemble the lug wrench to

the jack assembly and stow it in the spare tire area. Secure the assembly using the means

provided.

10. Place the deflated (flat) tire in the cargo area and have the tire repaired or replaced as

soon as possible.

11. Check the tire pressure as soon as possible. Correct the tire pressure as required.

Road Tire Installation

Vehicles Equipped With Wheel Covers

1. Mount the road tire on the axle.

2. To ease the installation process for steel wheels with wheel covers, install two lug nuts on

the mounting studs which are on each side of the valve stem. Install the lug nuts with the

cone shaped end of the nut toward the wheel. Lightly tighten the lug nuts.

3. Align the valve notch in the wheel cover

with the valve stem on the wheel. Install

the cover by hand, snapping the cover

over the two lug nuts. Do not use a

hammer or excessive force to install the

cover.

4. Install the remaining lug nuts with the

cone shaped end of the nut toward the

wheel. Lightly tighten the lug nuts.

5. Lower the vehicle to the ground by

turning the jack handle counterclockwise.

1 — Valve Stem 4 — Wheel Cover

2 — Valve Notch 5 — Mounting Stud

3 — Wheel Lug Nut

WHAT TO DO IN EMERGENCIES

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 107 108

Pas de commentaire

Chrysler 200 2012 Guide de l'utilisateur Page 74