Chrysler 2004 Sebring Coupe Manuel d'utilisateur télécharger pdf (Page 134)

Operation

Press and hold the desired button (A, B or C) on the

universal transceiver until the garage door or other

device begins to operate. The indicator light (D) shows

that the signal is being transmitted. The hand held

transmitter (E) may also be used at any time.

NOTE:

•

If you have difficulty in programming, call toll-free for

customer assistance at 1-800-355-3515, or the internet

at www.homelink.jci.com.

•

If your hand held transmitter appears to program the

universal transceiver, but your garage door or other

device does not operate, and your device was manu-

factured after 1996, your garage door opener or other

device may have a “Rolling Code” system.

To check if your device is protected by a “Rolling Code”

system:

•

Check the owner’s manual for the device for mention

of “Rolling Code”.

•

The hand held transmitter appears to program the

universal transceiver but the universal transceiver

does not activate the garage door.

•

Press and hold the programmed button on the univer-

sal transceiver. If the indicator light (D) flashes rapidly

and then stays on after 2 seconds, the device has the

“Rolling Code” feature.

“Rolling Code” Programming

On garage door openers with the “Rolling Code” feature,

the transmitter code changes after each use to prevent the

copying of your code. Set the universal transceiver by

following these steps:

NOTE:

•

The assistance of a second person may make the

following programming procedure quicker and easier.

134 INSTRUMENTS AND CONTROLS

1 2 ... 129 130 131 132 133 134 135 136 137 138 139 ... 381 382

Pas de commentaire

Chrysler 2004 Sebring Coupe Manuel d'utilisateur Page 134