Chrysler 2004 Town and Country Manuel d'utilisateur télécharger pdf (Page 133)

and, depending on the brand of the garage door opener

(or other rolling code equipped device), repeat this

sequence a third time to complete the programming.

HomeLink should now activate your rolling code

equipped device.

NOTE: To program the remaining two HomeLink but-

tons, begin with 9Programming9 step two. Do not repeat

step one. For questions or comments, please contact

HomeLink at www.homelink.com or 1-800-355-3515.

Canadian Programming/Gate Programming

Canadian radio-frequency laws require transmitter sig-

nals to 9time-out9 (or quit) after several seconds of

transmission which may not be long enough for

HomeLink to pick up the signal during programming.

Similar to this Canadian law, someU.S. gateoperators are

designed to 9time-out9 in the same manner.

If you live in Canada or you are having difficulties

programming a gate operator by using the 9Program-

ming9 procedures (regardless of where you live), replace

(Programming HomeLink( step 3 with the following:

NOTE: If programming a garage door opener or gate

operator, it is advised to unplug the device during the

9cycling9 process to prevent possible overheating.

3. Continue to press and hold the HomeLink button

while you press and release every two seconds (9cycle9)

your hand-held transmitter until the frequency signal has

successfully been accepted by HomeLink. (The indicator

light will flash slowly and then rapidly.) Proceed with

9Programming9 step four to complete.

Using HomeLink

To operate, simply press and release the programmed

HomeLink button. Activation will now occur for the

trained device (i.e. garage door opener, gate operator,

security system, entry door lock, home/office lighting,

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 133

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 400 401

Pas de commentaire

Chrysler 2004 Town and Country Manuel d'utilisateur Page 133