Chrysler 2012 200 - User Guide Manuel d'utilisateur télécharger pdf (Page 62)

Flashing Lights With Lock

• The turn signal lights flashing, when the doors are locked or unlocked, feature can be

turned on or off. To turn this feature on or off:

• Press and hold the UNLOCK button for at least 4 seconds, but no longer than

10 seconds. Then, press and hold the LOCK button while still holding the UNLOCK

button.

• Release both buttons at the same time.

UNIVERSAL GARAGE DOOR OPENER (HomeLink®)

• HomeLink® replaces up to three hand-held transmitters that operate devices such as

garage door openers, motorized gates, lighting or home security systems. The

HomeLink® unit is powered by your vehicles 12 Volt battery.

• The HomeLink® buttons that are located in the overhead console or sunvisor designate

the three different HomeLink® channels.

• The HomeLink® indicator is located above the center button.

Before You Begin Programming HomeLink®

• Be sure that your vehicle is parked outside of the garage before you begin programming.

• For more efficient programming and accurate transmission of the radio-frequency signal

it is recommended that a new battery be placed in the hand-held transmitter of the device

that is being programmed to the HomeLink® system.

• Erase all channels before you begin programming. To erase the channels, place the

ignition switch into the ON/RUN position, then press and hold the two outside

HomeLink® buttons (I and III) for up 20 seconds or until the red indicator flashes.

NOTE:

• Erasing all channels should only be performed when programming HomeLink® for the first

time. Do not erase channels when programming additional buttons.

• If you have any problems, or require assistance, please call toll-free 1–800–355–3515 or, on

the Internet at www.HomeLink.com for information or assistance.

ELECTRONICS

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 107 108

Pas de commentaire

Chrysler 2012 200 - User Guide Manuel d'utilisateur Page 62