Chrysler SRT8 2012 Manuel du propriétaire télécharger pdf (Page 389)

100

101

Installing And Removing The ENGINE

START/STOP Button

Installing The Button

1. Remove the key fob from the ignition switch.

2. Insert the ENGINE START/STOP button into the

ignition switch with the lettering facing up and readable.

3. Press firmly on the center of the button to secure it into

position.

Removing The Button

1. The ENGINE START/STOP button can be removed

from the ignition switch for key fob use.

2. Insert the metal part of the emergency key under the

chrome bezel at the 6 o’clock position and gently pry the

button loose.

NOTE: The ENGINE START/STOP button should only

be removed or inserted with the ignition in the LOCK

position (OFF position for Keyless Enter-N-Go).

Normal Starting

Using The ENGINE START/STOP Button

NOTE: Normal starting of either a cold or a warm

engine is obtained without pumping or pressing the

accelerator pedal.

To start the engine, the transmission must be in PARK or

NEUTRAL. Press and hold the brake pedal while press-

ing the ENGINE START/STOP button once. The system

takes over and attempts to start the vehicle. If the vehicle

fails to start, the starter will disengage automatically after

10 seconds. If you wish to stop the cranking of the engine

prior to the engine starting, press the button again.

STARTING AND OPERATING 387

1 2 ... 384 385 386 387 388 389 390 391 392 393 394 ... 580 581

Commentaires sur ces manuels

Pas de commentaire

Chrysler SRT8 2012 Manuel du propriétaire Page 389

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Chrysler SRT8 2012