Chrysler PT Cruiser 2008 Manuel du propriétaire télécharger pdf (Page 199)

100

101

Your vehicle should be parked outside of the garage

when programming.

1. Turn the ignition switch to the ON/RUN position.

2. Hold the battery side of the hand-held transmitter

away from the HomeLinkt button you wish to program.

Place the hand-held transmitter 1–3 in (3-8 cm) away

from the HomeLinkt button you wish to program while

keeping the indicator light in view.

3. Simultaneously press and hold both the chosen

HomeLinkt button and the hand-held transmitter button

until the HomeLinkt indicator changes from a slow to a

rapidly blinking light, then release both the HomeLinkt

and hand-held transmitter buttons.

Watch for the HomeLinkt indicator to change flash rates.

When it changes, it is programmed. It may take up to 30

seconds, or longer in rare cases. The garage door may

open and close while you train.

NOTE:

•

Some gate operators and garage door openers may

require you to replace Step 3 with procedures noted in

the “Gate Operator/Canadian Programming” section.

•

After training a HomeLinkt channel, if the garage

door does not operate with HomeLinkt and the ga-

rage door opener was manufactured after 1995, the

garage door opener may have a rolling code. If so,

proceed to the heading “ProgrammingARolling Code

System.”

4. Press and hold the just-trained HomeLinkt button

and observe the indicator light.

If the indicator light stays on constantly, programming is

complete and the garage door (or device) should activate

when the HomeLinkt button is pressed.

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 199

1 2 ... 194 195 196 197 198 199 200 201 202 203 204 ... 487 488

Commentaires sur ces manuels

Pas de commentaire

Chrysler PT Cruiser 2008 Manuel du propriétaire Page 199

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Chrysler PT Cruiser 2008