Chrysler 2004 Town and Country Manuel du propriétaire télécharger pdf (Page 471)

100

101

Installing And Removing The ENGINE

START/STOP Button

Installing The Button

1. Remove the key fob from the ignition switch.

2. Insert the ENGINE START/STOP button into the

ignition switch with the lettering facing up and read-

able.

3. Press firmly on the center of the button to secure it into

position.

Removing The Button

1. The ENGINE START/STOP button can be removed

from the ignition switch for key fob use.

2. Insert the metal part of the emergency key under the

chrome bezel at the 6 o’clock position and gently pry

the button loose.

NOTE: The ENGINE START/STOP button should only

be removed or inserted with the ignition in the OFF

position (OFF position for Keyless Enter-N-Go™).

Normal Starting

Using The ENGINE START/STOP Button

1. The transmission must be in PARK or NEUTRAL.

2. Press and hold the brake pedal while pressing the

ENGINE START/STOP button once.

3. The system takes over and attempts to start the

vehicle. If the vehicle fails to start, the starter will

disengage automatically after 10 seconds.

4. If you wish to stop the cranking of the engine prior to

the engine starting, press the button again.

NOTE: Normal starting of either a cold or a warm engine

is obtained without pumping or pressing the accelerator

pedal.

STARTING AND OPERATING 469

1 2 ... 466 467 468 469 470 471 472 473 474 475 476 ... 708 709

Commentaires sur ces manuels

Pas de commentaire

Chrysler 2004 Town and Country Manuel du propriétaire Page 471

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Chrysler 2004 Town and Country